How To Clean A Viva Water Cooler

IMPORTANT: Do NOT Return Dispenser To Store.

If you have a question or problem, please contact 888-925-2259 for

TO REDUCE THE RISK OF INJURY AND

PROPERTY DAMAGE, USER MUST READ

THIS MANUAL BEFORE ASSEMBLING,

INSTALLING & OPERATING DISPENSER.

SAVE FOR FUTURE USE

Hot and Cold Bottled

Water Cooler

Model # 7LIECH-SC-SSF

USER MANUAL

PN 7LIECH-S C-SSF © 20 12 Electrotemp Technologies Inc. BF 5M008973 X1 VA

Summary of content (14 pages)

• PAGE 1

  Hot and Cold Bottled Water Cooler Model # 7LIECH-SC-SSF USER MANUAL TO REDUCE THE RISK OF INJURY AND PROPERTY DAMAGE, USER MUST READ THIS MANUAL BEFORE ASSEMBLING, INSTALLING & OPERATING DISPENSER. SAVE FOR FUTURE USE IMPORTANT: Do NOT Return Dispenser To Store. PN 7LIECH-SC-SSF © 2012 Electrotemp Technologies Inc.

• PAGE 2

  SAFETY PRECAUTIONS To reduce risk of injury and property damage, user must read this entire manual before assembling, installing & operating dispenser. Failure to execute the instructions in this manual can cause personal injury or property damage. This product dispenses water at very high temperatures. Failure to use properly can cause personal injury.

• PAGE 3

  SAFETY PRECAUTIONS ---- Electrical Requirements Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. A 120 volt, 60 Hz., AC only, 15 amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. Do not overload the ciruit, provide separate circuit, if required, to serve only this appliance.

• PAGE 4

  TABLE OF CONTENTS Safety Precautions 2 Safety Precautions-Electrical Requirements 3 4 . Key Information for Future Use 5 Specifications 5 .. Parts & Features 6 Assembly Cleaning prior to initial use . Installation Installing the Correct Bottle Receptacle . 7 . 8 9 ... Operation .. 10 Proper Care & Cleaning . 11 Troubleshooting 12 Limited Warranty 13 KEY INFORMATION FOR FUTURE USE Please register your dispenser immediately at www.electrotemp.

• PAGE 5

  SPECIFICATIONS Power Supply 4.5 AMP Refrigerant Type R-134A Cold Water Power 100 Watts Cold Capacity / Peak Hour 1.0 Gallon / 3.79 L Cold Temp Range 3°C – 10°C / 37.4°F - 50°F Hot Water Power 425 Watts Hot Capacity / Peak Hour 1.0 Gallon / 3.79 L Hot Temp Range 80°C – 92°C / 176°F - 197.6°F Dimensions 91.3 H x 27.5 W x 28.6 D (cm) 35.4 H x 10.8 W x 11.3 D (inch) Net Weight 27.9Ibs/12.

• PAGE 6

  ASSEMBLY To prevent accidental tip hazard, base supplied must be securely fixed to the dispenser as shown. Do NOT operate dispenser without base properly installed. Keep plastic bags away from children. 1. Remove dispenser from packaging. 2. Lay dispenser on its back. 3. Position cooler upright. Unpack drip tray and insert into dispenser. 4. Properly dispose all of packaging. 7. C IMPORTANT: Do NOT Return Dispenser To Store.

• PAGE 7

  CLEANING PRIOR TO INITIAL USE To remove any odors or dust that may collect during shipment, you must clean dispenser prior to first use. DO NOT PLUG THE COOLER INTO AN ELECTRICAL POWER OUTLET Time Required: 40 minutes. 1. Remove bottle receptacle by turning it counter clockwise and pulling up. Store in a safe place. 2. Remove plastic baffle from inside reservoir. Clean with warm soapy water, rinse, then store in a safe place. 3.

• PAGE 8

  INSTALLATION To prevent accidental tip hazard, dispenser must be securely anchored to wall as shown. 1. Place dispenser upright. 2. Locate dispenser on a hard and level surface in a cool shaded location near a grounded wall outlet. Notice: Do NOT plug in power cord yet. 3. Position dispenser so the back is at least 4 inches from wall and there are at least 4 inches of clearance on both sides. 4. Install Wall Mount Strap to prevent accidental tip over: • Unclip strap from back of dispenser.

• PAGE 9

  INSTALLING THE CORRECT BOTTLE RECEPTACLE Then Use This Bottle Receptacle If Your Water Bottle Looks Like This model comes set up with a Probe Receptacle (1). No changes are required. The Probe will push the Plug out of the way when you place the bottle into the receptacle. Then Use This Bottle Receptacle If Your Water Bottle Looks Like 1. 3. Remove bottle receptacle (1) by turning it counter clockwise and pulling up. Remove Collar (2) from foam packaging or bag at front of dispenser. Align tabs. 4.

• PAGE 10

  OPERATION This unit is intended for water dispensing only. Do NOT use other liquids. Do NOT use for other purposes. Warranty is void if used for any other liquids including coffee, tea, juices, beer or wine. This dispenser has been designed to use water bottles with 3 & 5 gallon capacity. Do NOT use alternative bottles. Initial Set Up Notice: To prevent damage to compressor, allow unit to sit upright for at least 4 hours prior to operating. 1. Remove tamper seal from bottle cap. Do NOT remove plastic cap.

• PAGE 11

  PROPER CARE & CLEANING General Cleaning Perform: As needed Time Required: 5 minutes. Note: Do NOT use abrasive materials or chemical cleaners. 1. Clean cabinet surfaces with a soft cloth and warm soapy water, then rinse. 2. Wipe dust from back of dispenser to improve efficiency. 3. Remove drip tray assembly by pulling it forward. Remove cover. Place tray and cover in dishwasher or wipe parts clean with a soft cloth and warm soapy water.

• PAGE 12

  TROUBLESHOOTING Dispenser does not operate. • Make sure the power cord is properly connected to a working outlet. Water is leaking. • Call 855-VIVA-111 for assistance. Push buttons are stuck and/or faucets are leaking. • Apply mineral oil (baby oil) to button slides to reduce friction. No water is coming from the taps. • Make sure the bottle is not empty. If so replace it. • Make sure to push the water controls in fully. • Remove bottle receptacle as per page 6 step 1.

• PAGE 13

  LIMITED WARRANTY Electrotemp Technologies Inc., ("Vendor") warrants to the original purchaser of this dispenser, and to no other person, that if this dispenser is assembled and operated in accordance with the printed instructions accompanying it, then for a period of one (1) year from the date of purchase, all parts in such dispenser shall be free from defects in material and workmanship. Vendor may require reasonable proof of your date of purchase from an authorized retailer or distributor.

• PAGE 14

  版本号 修订 A 修订内容 对应铭牌，重量由13.1Kg更改为12.

How To Clean A Viva Water Cooler

Source: https://www.manualshelf.com/manual/viva/7liech-sc-ssf/use-and-care-manual.html

Posted by: fosterwhippyraton.blogspot.com

Share this post